hestan KDW Série Manuel D'entretien page 15

FEATURES AND CONTROLS
HALF LOAD
Suitable when there are not many dishes to be washed, it saves energy
and reduces the program duration. Place dishes in both baskets then
load the detergent dispenser (see page 23) less than the normal amount
for a full load.
ENERGY SAVER
This option can be selected with the wash cycle of choice
to further reduce energy consumption. Drying is aided by a
special device that automatically releases the door, which opens
slowly and smoothly by about an inch. This ensures perfect
drying and greater control of rinsing temperatures, which can
be kept at lower levels for significant energy saving. Once the
door has opened, the end of the wash cycle is indicated by a
short beep.
Enersaver is activated automatically every time a wash cycle
is selected (except for cycles that do not include the final
drying phase) and can be disabled before the cycle is started.
the program is started.
When the function is activated, opening of the door must not
˜˜ ˜
be impeded in any way; do not leave anything in the space in
front of the door necessary to allow it to open.
Do not re-close the door during automatic opening as this
would damage the mechanism. Wait for the mechanism to
retract before re-closing the door.
TURNING OFF
At the end of the cycle, the dishwasher emits a short beep and the indicator
LED's of the fourth and fth cycle ash. Turn off the appliance by opening
the door and pressing the ON/OFF button.
If it is necessary to open the door during the washing cycle, the
cycle will be interrupted, the relative indicator light will continue to
fl ash and a beep will indicate that the cycle has not terminated. Wait
for 1 minute before closing the door and continuing with the cycle.
When the door closes, the cycle will start from where it was interrupted.
This operation should be performed only if necessary as it could cause
irregular performance.
ENERGY MANAGEMENT
After 5 minutes of waiting (wash cycle completed, stopped
or set but not started) the dishwasher switches to a standby
state to reduce energy consumption.
In this state, the dishwasher indicator panel (lights/display)
functions more intermittently, switching on every 5 seconds.
REMOVING DISHES
˜˜ ˜
At the end of the wash cycle, wait 20 minutes before removing the
˜˜
dishes in order to allow them to cool. To prevent any water droplets
falling onto dishes from the upper racks, empty the lower rack items
rst and then the upper items.
(continued)
Crystal Delicate Daily Wash
Soak
Super/
Sanitize
©2018 Hestan Commercial Corporation
EN
13