Cleaning The Water Intake Filter; Cleaning The Spray Arms - hestan KDW Série Manuel D'entretien

CLEANING AND USER MAINTENANCE

CLEANING THE WATER INTAKE FILTER

EN
Clean the water inlet lter at regular intervals. After closing the delivery tap, unscrew
the ring nut (A ) on the water inlet pipe (using a pair of pliers, if necessary) and
and delicately clean the lter, removing deposits or impurities.
Then rmly x the pipe by tightening the ring nut (use a pair of pliers if necessary).

CLEANING THE SPRAY ARMS

The spray arms can be easily removed for periodic cleaning of the nozzles, to
prevent possible clogging. Wash them under running water (at room temperature)
and carefully replace them in their seats, checking that their rotary movement is in no
way impeded; if this is not the case, make sure they have been mounted properly.
Removing the spray arms
• To remove the upper spray arm ( A), unscrew the locking ring (B )
by turning it clockwise. After cleaning, remount the spray arm in its seat
and tighten the locking ring by turning it anti-clockwise.
• To remove the orbital spray arm assembly (A ), take hold of the lower
arm (B ) and pull the orbital unit upward.
After cleaning, remount the orbital spray arm in its seat and push it down slightly
until it clicks into place on the lower spray arm. Then remount the lower
spray arm into its seat and push it down slightly until it click into place.
28
©2018 Hestan Commercial Corporation
A
B
(continued)
A