Parts / Service; Service Data Record; Parts List - hestan KDW Série Manuel D'entretien

INSTALLATION AND HOOK-UP
EN

PARTS / SERVICE

SERVICE DATA RECORD

The location of the serial tag on the product can be seen when the dishwasher door is opened.
It is located on the right side of the door edge.
Now is a good time to write this information in the space below provided. Keep your invoice
for warranty validation.
Model Number _________________________________
Serial Number __________________________________
Date of Installation or Occupancy __________________

PARTS LIST

Please visit the Hestan website to access the parts list for your Hestan Indoor product:
www.hestanhome.com
SERVICE
All warranty and non-warranty repairs should be performed by qualified service personnel.
To locate an authorized service agent in your area, contact your Hestan dealer, local
representative, or the manufacturer. Before you call, please have the model number and serial
number information ready.
Hestan Commercial Corporation
3375 E. La Palma Avenue
Anaheim, CA 92806
(888) 905-7463
32
©2018 Hestan Commercial Corporation
CHECK THAT THE MAIN SUPPLY IN THE PLACE OF INSTALLATION
COMPLIES WITH THE REGULATIONS IN FORCE IN THE COUNTRY OF
USE, AND THAT IT IS CORRECTLY GROUNDED.
THIS APPLIANCE MUST BE GROUNDED. IN CASE OF A MALFUNCTION OF
FAULT, THE EARTH REDUCES THE RISK OF ELECTROCUTION BY
PROVIDING THE ELECTRICAL CURRENT WITH AN ALTERNATIVE, LESS
RESISTANT PATH. THIS APPLIANCE IS FITTED WITH A SUPPLY CORD
CONTAINING AN EARTH WIRE AND PLUG. FIT THE PLUG INTO A SUITABLE
SOCKET, INSTALLED AND EARTHED IN COMPLIANCE WITH THE
LAWS IN FORCE IN THE COUNTRY OF INSTALLATION.
AN INCORRECTLY CONNECTED EARTH WIRE MAY GENERATE THE RISK
OF ELECTROCUTION. IF IN DOUBT AS TO THE CORRECT EARTHING OF
THE APPLIANCE, CALL IN A QUALIFIED ELECTRICIAN OR TECHNICAL
SERVICE. DO NOT CHANGE THE PLUG ATTACHED TO THE APPLIANCE.
IF THE PLUG IS NOT SUITABLE FOR THE SOCKET, CONTACT A
QUALIFIED ELECTRICIAN TO FIT A SUITABLE PLUG.
IN THE EVENT OF DAMAGE TO THE SUPPLY CORD, HAVE IT REPLACED
BY THE MANUFACTURER OR AN AUTHORIZED TECHNICAL SERVICE
CENTER IN ORDER TO AVOID ANY RISK.
DO NOT USE EXTENSION CORDS, ADAPTORS OR SHUNT CONNECTIONS
IN ORDER TO AVOID THE POSSIBILITY OF OVERHEATING OR BURNING,
WITH CONSEQUENT FIRE HAZARD.
(continued)
-