Serial Output Setup - Adam Equipment Solis SAB Série Mode D'emploi

10.2

SERIAL OUTPUT SETUP

Different data transmission devices and modes can be selected.
1. Select the serial output parameter as described in paragraph 10.
The current set transmission mode will be shown on the display:
2. Now by pressing the MENU or CAL button it will be possible to scroll through the serial
output MENU forward or backward.
3. Then press the PRINT button to confirm the desired transmission mode.
The different transmission modes are illustrated below:
TRANSMISSION MODE FEATURES
Continuous
On demand
Generic printer
Tlp50 printer
Upon request - Glp
Generic printer - Glp
TLP – Glp printer
NOTE: transmission speed selection (paragraph 10.3)
4. After having selected the desired transmission mode, the screen relative to the balance
parameters menu will be displayed again. It will now be possible to select another
parameter or return to weighing mode by pressing the ON/OFF button.
©Adam Equipment Co. Ltd. 2018
Transmits the weight data in a continuous way
Transmits the weight data only when the PRINT button is
pressed
The weight data is printed only when the Busy command is
active
The weight data is printed only if the Tlp50 model printer is
connected
Transmits the weight data and the Glp information only when the
PRINT button is pressed
The weight data and the Glp information are printed only when
the
Busy command is active
The weight data and the Glp information are printed only if the
Tlp50 model printer is connected
21