Adam Equipment Solis SAB Série Mode D'emploi page 39

If there are enough samples (e.g. 10 as in the figure), the number of parts loaded will appear
on the display. It will now be possible to proceed with the counting of the parts.
If the parts to be counted have a weight that is too little with respect to the balance's resolution,
an error message will be displayed. In this case it will be necessary to weigh on a balance with
greater resolution.
If the weight of the samples is acceptable but not sufficient, the following message will be
displayed: Add enough parts so as to approximately double the quantity loaded on the plate,
then press the PRINT button.
If the number of parts is still insufficient, the message indicated above will be displayed again.
Double the quantity of parts loaded again.
Once a sufficient number of parts has been reached, their number will be displayed and it will
be possible to proceed with the counting, loading the parts to be counted on the plate.
©Adam Equipment Co. Ltd. 2018
37