Checkweighing Function - Adam Equipment Solis SAB Série Mode D'emploi

12. To exit from the screen and carry out a new formulation, press the ON/OFF button once.
To exit from the program and return to the weighing screen, press the ON/OFF button two
consecutive times.
To interrupt and exit from the formulation function at any time, press the ON/OFF button.
11.4

CHECKWEIGHING FUNCTION

The checkweighing function allows you to determine if the weight loaded on the weighing pan
is above or below two limits pre-set by the user.
1. Select the limits function as described in paragraph 10. The following screen will be shown
on the display:
2. Enter the MINIMUM limit value by using the CAL and MENU buttons to increase and
decrease the value, while pressing the O/T button to pass to the next number. During the
entering phase, prolonged pressure on the O/T button allows you to delete the entered
value.
3. Then press the PRINT button to confirm. The entered value will remain in memory until the
balance is turned off.
4. The following screen will then be displayed.
©Adam Equipment Co. Ltd. 2018
51