HEADRUSH Expression Pedal Guide D'utilisation page 6

Setup with the HeadRush Looperboard
When connected to a HeadRush Looperboard, you
can use the HeadRush Expression Pedal to control
up to 4 parameters at a time, including FX Rack
Parameters, Track Volume, and Track Panning. For
more information on assigning parameters from your
rig to the HeadRush Expression Pedal, please
consult the HeadRush Looperboard User Guide
available at headrushfx.com.
To set up the HeadRush Expression Pedal with
the HeadRush Looperboard:
Connect the Expression output of the HeadRush
Expression Pedal to the EXPR input using a
standard 1/4" (6.35 mm) TRS cable. The HeadRush
Expression Pedal will now control any assigned
parameters for a loop.
Note: The HeadRush Expression Pedal's built-in
toe-switch feature
HeadRush Looperboard.
Setup with other devices
Other devices such as guitar effects processors, vocal effects processors, keyboards, etc. may also
be compatible with the HeadRush Expression Pedal. If you are unsure if your device is compatible
with the HeadRush Expression Pedal, please consult the device's manual or manufacturer to confirm
that the specifications listed in the end of this manual match the device's requirements.
To set up the HeadRush Expression Pedal with other devices:
1. If your device has an input for an expression pedal, connect the Expression output of the
HeadRush Expression Pedal to this input using a standard 1/4" (6.35 mm) TRS cable.
2. If your device has an input for a toe switch, connect the Toe output of the HeadRush
Expression Pedal to this input using a standard 1/4" (6.35 mm) TS cable.
3. If necessary, change any settings on your device to enable the functionality of the expression
pedal and toe switch.
6
is not supported by the