HEADRUSH Expression Pedal Guide D'utilisation page 4

Operation
Setup with the HeadRush Pedalboard
When connected to a HeadRush Pedalboard, you
can use the HeadRush Expression Pedal to control
the parameter(s) assigned to Bank B of a rig. For
more information on assigning parameters from
your rig to the HeadRush Expression Pedal, please
consult the HeadRush Pedalboard User Guide
available at headrushfx.com.
To set up the HeadRush Expression Pedal with
the HeadRush Pedalboard:
1. Connect the Expression output of the
HeadRush Expression
HeadRush Pedalboard's EXPR 2 input using
a standard 1/4" (6.35 mm) TRS cable.
2. On the HeadRush Pedalboard, tap the ...
icon on the top right of the screen and then
tap Global Settings to enter the Global
Settings menu.
3. In the Global Settings menu go to page 3 by
selecting/tapping the 3 on the bottom of the
Global Settings menu.
4. On Global Settings page 3, turn Pedal
Configuration's External Pedal from Off to
On.
The HeadRush Expression Pedal will now
control the parameter(s) assigned to Bank B
of a rig.
Note: The HeadRush Expression Pedal's built-in toe-switch feature is not supported by the
HeadRush Pedalboard. If you are using the Classic mode for the expression pedal of a rig, the
HeadRush Pedalboard's internal pedal toe switch will activate or deactivate parameter(s)
assigned to Bank A only. If you are using the Advanced mode for the expression pedal of the
rig, the HeadRush Pedalboard's internal pedal toe switch will be disabled entirely.
4
Pedal to the
RIGHT LEFT (MONO)
SEND
EXPR 2 GND RIGHT LEFT (MONO) PHONES RIGHT LEFT (MONO)
AUX IN LIFT
AMP LINE RACK STOMP
EXH AUS T- DO N OT BLOCK
RETURN IN OUT/ THRU
RIGHT LEFT (MONO)
USB
POWER
PATE NT PENDING