Publicité
Les langues disponibles
Les langues disponibles
Important information
Mounting instructions information
These mounting instructions come as part of
the Duravit shower-toilet and should be read
carefully prior to installation.
Explanation of the key words and symbols
Indicates a hazardous situation
DANGER
which, if not avoided, will result
in death or serious injury.
Is used to address practices
NOTICE
not related to physical injury.
Link to the mounting information in
this section
Target readership and qualifications
The shower-toilet and associated water
connection should only be installed by qualified
plumbers. The electrical installation should
only be carried out by qualified electricians.
Risk of product and/or
NOTICE
property damage!
> Observe the local installation regulations and
any country-specific standards at all times.
Risk of product damage due
NOTICE
to freezing water!
> Do not install the shower-toilet in rooms at
risk of frost. The room temperature must
not be less than 4 °C (39 °F).
Risk of product damage due
NOTICE
to condensation!
> Leave the unit switched off for a few hours
if it has previously been moved from a cold
location to a warm location.
Safety instructions
DANGER
Risk of fatal electric shock!
> Do NOT remove individual shower-toilet
components.
4
70300083_MAL_SensoWash_Slim_PP_RE_TW
> If the supply cord on this unit is damaged, it
must be replaced by the manufacturer, the
service agent or similarly qualified persons
in order to avoid a hazard.
> Appliances have to be correctly grounded.
> The product itself does not have electrical
leakage protection function, it must be
installed in circuit where there is leakage
protection device installed.
> Means for disconnection must be
incorporated in the fixed wiring in
accordance with the wiring rules and
having a contact separation in all poles that
provide full disconnection under overvoltage
category III conditions.
> Wire specification of cable is cross section
1 – 2.5 mm
(17 – 14 AWG).
2
> Confirm that the grounding wire is
10 mm (⅜") longer than the L and N wire.
Mounting instructions
Please read pre-installation information
sheets prior to the installation. These are
available to download at
www.duravit.com.
Checking the installation requirements
1
The installation of the WC ceramics with
pre-installation of the shower-toilet water
and power supplies is described in
separate instructions.
> Confirm that the electric connection box
must be fixed on wall before installation.
> Ensure that the supplies and WC
ceramics have been installed and
mounted according to the instructions
and regulations.
Testing
35
> Connect the power and water supply.
> Confirm that the product functions
properly according to the operating
instructions.
Publicité
