Possible Causes - Bosch Sensixx B20L Notice D'utilisation

2. Place your appliance on the edge of your
kitchen sink.
3. Remove the plastic cover located on the bottom
of the appliance by turning it to the
4. Unscrew the boiler drainage plug using a coin.
5. Holding your steam generator in upside down
position, and using a jug, fill the boiler (in the
base unit) with 1/4 litre of water
6. Shake the base unit for a few moments and
then empty it completely over a sink or bucket.
To obtain the best result, we recommend that
this operation is done twice.
important: before re-closing, make sure no
water remains in the boiler.
7. Replace and tighten up the boiler drainage
plug with a coin.
8. Insert and close the plastic cover by turning it
to the position.
Rinsing the iron steam
g
chamber
Caution! Risk of burns!
This procedure helps to remove scale particles
out of the steam chamber.
This cleaning procedure may be performed
occasionally (approximately once a year), when
after a long period of use with very hard water,
scale particles start to come out of the soleplate.
a) Ensure that the iron is cooled down.
Trouble shooting
Problem
The steam
generator does not
come on.
The iron does not
heat up.
The iron begins
to smoke when
switched on.
position.

Possible causes

1. There is a connection problem.
2. The main power switch is not
switched on.
1. The main power switch is not
switched on.
2. The temperature control knob is
set to the "min" position.
1. During first use: Certain
components on the appliance
have been lightly greased at the
factory and may produce a little
smoke when initially heated.
2. During later use: the soleplate
may be soiled.
b) Set the temperature selector (13) of the iron to
the "min" position.
c) Fill the tank with tap water.
d) Plug in the mains cable and set the main
power switch (11) to the "I" position.
e) Wait until the "steam ready" indicator lamp (8)
lights up.
f) Hold the iron over the sink or a container to
collect the water.
g) Press the steam release button (14) and gently
shake the iron. Boiling water and steam will
come out, carrying scale and or deposits that
might be there. This could take approximately
5 minutes.
h) Set the temperature selector (13) of the iron
to the "max" position, without pressing the
steam release button (14). The water in the
steam chamber will start evaporating. Wait
until all the water inside the chamber has been
evaporated.
i) To clean the soleplate, immediately rub off any
residue by running the hot iron over dry cotton
cloth.
Solution
1. Check the mains cable, the plug and
the socket.
2. Set the main power switch (11) to the
"I" position.
1. Set the main power switch (11) to the
"I" position.
2. Set the temperature selector (13) to
the desired position.
1. This is completely normal and will stop
after a short while.
2. Clean the soleplate according to the
cleaning instructions in this manual.
17
B OSCH