Siemens SITRANS F FUT1010 Instructions De Service page 27

8. Replace access cover. Make sure Keypad Enable switch is in the "Enable" position (see
9. Connect the power cables to the appropriate power source (100-250 VAC @ 50/60 Hz or
FUT1010 IP65 NEMA 4X & IP66 NEMA 7 Gas Quick Start
Operating Instructions, 1/2013, A5E02639183-AC
below).
①
Keypad Enable Switch
CAUTION
Power Supply Damage
Improper power connections will damage power supply and may result in injury.
Ensure that all AC or DC power supply connections are properly connected to the
appropriate power source (100-250 VAC @ 50/60 Hz or 9-36 VDC).
9-36 VDC). Close top cover.
Connecting
3.1 Transmitter Wiring
25