EGO Power+ STX3800 Guide D'utilisation page 20

Before each use check for damaged/worn parts
Check the trimmer head, guard, and loop handle and replace any parts that are
cracked, warped, bent, or damaged in any away.
The line-cutting blade on the edge of the guard can dull over time. It is recommended
that you periodically sharpen it with a file or replace it with a new blade.
WARNING:
sharpening or replacing the blade. Note the location of the blade on the guard and
protect your hand from injury.
Clean the trimmer after each use
See the maintenance section for cleaning instruction.
WARNING:
when cleaning plastic parts. Most plastics are susceptible to damage from various
types of commercial solvents. Use clean cloths to remove dirt, dust, oil, grease, etc.
STARTING/STOPPING THE STRING TRIMMER
To Start
1. Push the on-off switch to the "ON"
position.
2. Move the lock-off trigger forwards
and then press the main trigger. The
string trimmer will start. The more
you pull up the main trigger, the
higher rotating speed the trimmer
head is (Fig. 12).
To Stop
1. Move the string trimmer away from the cutting area and release the main trigger
to stop the tool.
2. Push the on-off switch to the "OFF" position to help to avoid accidental starting.
WARNING:
breaks and after finishing work.
20
56-VOLT LITHIUM-ION REAR-MOTOR 15" STRING TRIMMER — STX3800
Always wear gloves when mounting or replacing the guard or when
Never use water for cleaning your trimmer. Avoid using solvents
Always remove the power plug from the string trimmer during work
12 On-off Switch
Main Trigger
Lock-off Trigger