Scanner Installation Problems - HP scanjet 8200 Série Guide De L'utilisateur

chapter 2
maintain the ADF
If an unusual number of misfeeds occur, follow these steps:
• Clean the ADF to help reduce misfeeds. See clean the ADF on page 10.
• See the HP Scanject 8200 series help – ADF problems.
• If that does not help, install the ADF Roller Replacement kit (C9937-
68001). The ADF Roller Replacement kit contains a roller mechanism, a
separation pad, and a wrench used to replace the separation pad. See
purchase maintenance parts on page 31.
The ADF Roller Replacement kit contains instructions for replacing the
parts.
ordering maintenance supplies
You can purchase maintenance parts online at www.hp.com. Use search to find
the item, such as cleaning cloth, or ADF Roller Replacement kit.

scanner installation problems

If an "Error 04" in the front panel displays, it indicates that a Hi-Speed USB
connection error has occurred. Ensure that the Hi-Speed USB cable is securely
connected between the scanner and the computer.
• First, check your computer:
–
–
• On a Microsoft® Windows computer, if you receive a message, such as
"Destination Directory Is Invalid" or "Program Folder Is Invalid" during
installation, do one of the following:
–
–
• Check the cables:
–
–
–
–
–
–
• Enter the scanner diagnostic mode:
12
Ensure that your computer meets the minimum system requirements that
are listed on the scanner box.
If you do not have enough hard-disk space, remove unnecessary files
or install the software on a different disk drive.
Type a valid destination folder name. The destination folder cannot
contain the following characters: /, \, :, ?, *, <, >, ", or |.
Find a valid folder using the Browse button.
Ensure that the power cable is securely connected between the scanner
and a live electrical outlet or surge protector.
If the power cable is connected to a surge protector, ensure that the
surge protector is plugged into an outlet and turned on.
Use the Hi-Speed USB cable that was included with the scanner. Other
Hi-Speed USB cables might not be compatible with the scanner.
Ensure that the Hi-Speed USB cable is securely connected between the
scanner and the computer.
Disconnect the power cable from the scanner and turn off the computer.
After 30 seconds, reconnect the power cable to the scanner and then
turn on the computer, in that order.
On a Macintosh computer, use the Apple System Profiler to ensure that
the scanner is connected to the computer correctly.
hp scanjet 8200 series