DeWalt DW872 Mode D'emploi page 7

392736-01,00,DW872 6/29/00
FIG. 7
B
A
FIG. 8
A
FIG. 9
B
9:00 AM Page 5
D
E
C
A
the hex wrench rotate the bolt cover (B) out of the way and loosen
the bolt (C) counterclockwise. Then remove the bolt (C), lock
washer (D), the flat washer (E) and the outer clamp washer (F).
4. Install blade (G) oriented as shown against the inner clamp
washer (H). Reassemble the outer clamp washer, flat washer,
lock washer and bolt hand tight.
5. With blade lock engaged, tighten the bolt securely with the hex
wrench.
6. Remove hex wrench then release lower guard and blade lock
lever.
7. Use same steps to remove the blade.
DO NOT MAKE ANY ADJUSTMENT WHILE TOOL IS PLUGGED
INTO POWER SUPPLY.
WARNING: VISUALLY CHECK BLADE FOR CRACKS OR
OTHER DAMAGE. VERIFY PROPER BLADE INSTALLATION
BEFORE USE. IF BLADE IS DAMAGED IN ANY WAY, HAVE IT
RECONDITIONED AT A QUALIFIED SAW BLADE SERVICE
SHOP.
WARNING: BE SURE THE BLADE BOLT IS TIGHTENED
SECURELY AND THE BOLT COVER IS COVERING THE BOLT
HEAD BEFORE CUTTING.
Auto Retracting Guard (Fig. 5)
This tool has an automatic retracting lower guard system. The blade
is exposed as it approaches the material and is covered in the up
position.
• When cutting very large pieces, it may be necessary to manually
assist the guard in retracting. To accomplish this, rotate the guard
(A) slightly by the lip (B), just enough to clear the workpiece and
release.
• Keep hands and other body parts away from rotating blade.
• Do not remove blade guard system.
• Keep guard system in good operating condition.
5