Ayce ALUMINIO Mode D'emploi page 25

Base installation instruction:
Fix 2 base on the fan by screw
Battery installation instruction:
Press
Pull
Remove the battery door, insert 2 batteries in the battery casing and
close the battery door.
Notice:
1. The anode and cathode of the batteries must be corresponding to
the signs of "+" and "-" on the remote controller.
2. For long time no use, take out the battery.
3. To prevent environmental pollution, take out the used battery and
dispose safety and appropriately.
Spring " "Side
How to Use
To operate the air fan, aim the Remote controller at the signal
receptor. The remote controller at distance of up to 5m when
pointing at signal receptor of the air fan.
Remote Control:
Control Panel:
Operation:
1. Before connect the fan to a power supply. Make sure the Recharge
Switch is at "0" OFF position. Plug the power cord into a suitable
electrical outlet. Turn ON the Recharge Switch at "1" ON position.
2. It needs to be charged for 30 min at least to fully charge the
48 49 G