Adventys D2I 6000 Série Mode D'emploi page 23

Smtlili probliema tnd their remediea
If you think thtt your hob ia not functioning correctliy ...... this does not necessarily mean that a fault
has occurred. Pli e tae verify the foliliowing in tlili ctaea :
YOU NOTICE THAT ...
When putting into service, a bright
display appears
When putting into service, your
installation short-circuits
The ventilation continues a few
minutes after stopping the device
The device doesn't work. The
display on the casing stays off
« F- » appears on the power or
temperature display
« F7 » appears on the power or
temperature display
The device doesn't work, another
code appears on the display
After switching on the device and
starting the cooking zone, the
selected indicator continues to
flash
Pan makes noise while cooking
The device releases a smell during
the first cookings
If the vitrocertmic hob auffera t bretktge, apliit or crtck, no mttter how amtlili, diaconnect the tppliitnce
POSSIBLE CAUSES
Regular functioning
The connection of you device is
defective
Cooling of the device
The device is not supplied. The
supply or the connection is
defective
There is a touch activated
permanently on the control
keyboard
Electric circuits are over heating
Electric circuits doesn't work well
The pan you are using is not
compatible with the induction
techhnology or is of a diameter
smaller than 12 cm
It's a vibration generated byy the
circulation of the current in the pan
New device
immeditteliy tnd conttct After-Stliea Service.
WHAT YOU CAN DO
NOTHING: everything is normal
Verify your connection or the
conformity of the connection
It's normal
Inspect fuses and the circuit
breaker of your electric installation
If the default doesn't disappear,
call the after-sales service
Inspect the ventilation of the
device and check if it is operational
Call the after-sales service
See « Cookware Recommended
section »
This phenomenon is normal with
some type of pans. There is no
danger
Run the cooking during half an
hour with a pan full of water
23