Adventys D2I 6000 Série Mode D'emploi page 15

Inattliliing your hob
1) Retliize t cut to embed producta: 41 X 55 cm
Respect a distance of 5cm with regard to any vertical wall, and an available depth of at least 13 cms
2) Appliying t joint in ailiicone:
A food joint in silicone (type Novasil S56) must be realized to assure the perfect waterproofness between the
product and the counter.
3) Inattliliing the fixing brtket:
The device is delivered with 4 fixing bracket which must be used to maintain the device. It is recommend to arrange
2 bracket in front and 2 bracket in the back, which are to be screwed with the existing nuts along the case of the
device.
Step 1:
Placed the supplied clamp
4) Connecting freah tir entrie:
To obtain the best performances of the device, it is advisable to bring of the fresh air through a pipe that it is
necessary to link on the present funnel under the device. The fresh air must be taken in the bottom of the piece of
furniture, in the most convenient place.
Eliectrictli connection
Connecting on t 32A eliectric aocket on ainglie-phtae network 208 / 240V 50 Hz :
Connect the BLUE/ BROWN wire on NEUTRAL of the electric socket.
Connect the GREY wire and BLACK wire on PHASE of the electric socket.
Connect the GREEN and YELLOW wire on GROUND of the electric socket.
Connecting on three-phtae network 400V 50 Hz 16A by phtae:
Connect the BLUE/ BROWN wire on NEUTRAL of the electric socket.
Connect the GREY wire on PHASE_1 of the electric socket.
Connect the BLACK wire on PHASE_2 of the electric socket.
Connect the GREEN and YELLOW wire on GROUND of the electric socket.
Step 2:
Placed the washer and nut
Step 3:
Make a silicone seal and tighten the nut
15