Roland JP-8000 Aide-Mémoire D'utilisation page 42

The File names included are as follows:
_00001.mid
_00002.mid
_00003.mid
_00004.mid
_00005.mid
_00006.mid
_00007.mid
_00008.mid
Update Procedure:
1) Connect the sequencer MIDI-OUT to the JP-8000 MIDI-IN.
2) Turn on the power of the JP-8000 while holding down the [LFO1 WAVEFORM],
[OSC1 WAVEFORM], [OSC2 SYNC] and [OSC2 WAVEFORM] buttons.
3) Press REC.
4) When 'Ready to update' appears on the screen, send the first file (_00001.mid)
from your sequencer.
5) When the file is completed, verify that the checksum is indicated as below.
Block1 ( chksum = 49F8 ) => filename : '_00001.mid'.
Block2 ( chksum = 12E3 ) => filename : '_00002.mid'.
Block3 ( chksum = A146 ) => filename : '_00003.mid'.
Block4 ( chksum = E6EB ) => filename : '_00004.mid'.
Block5 ( chksum = 5455 ) => filename : '_00005.mid'.
Block6 ( chksum = 672D ) => filename : '_00006.mid'.
Block7 ( chksum = C131 ) => filename : '_00007.mid'.
Block8 ( chksum = F294 ) => filename : '_00008.mid'.
If the value is different, press [EXIT] and repeat steps 4 and 5.
6) If the value is correct, press the [REC] button.
7) Load the files one at a time, in sequence _00002.mid to _00008.mid and repeat steps 4-6.
8) One all the files have been loaded, 'Completed' will be indicated on the screen.
Turn off the power of the JP-8000.
Reset Pitch Bender and Ribbon Controller Procedure:
1) Turn on power while holding [OSC2 SYNC], [-12dB/-24dB] and [FILTER TYPE] to enter
Test Mode. Wait until display indicates "[1] MIDI Test."
2) Press the [3] button to display "[3] Bend Mod."
3) Push the bender lever left fully and gradually return it to the center. Press [LOWER].
4) Push the bender lever right fully and gradually return it to the center. Press [UPPER].
5) Push the bender lever to the MOD position and then gradually return it to the original
position. Press [KEY MODE].
6) When the '*' appears on the display, press [UP].
7) From the previous display, press [4] to display "[4] Ribbon."
8) While pressing down on the left edge of the ribbon controller, press [LOWER].
9) While pressing down on the right edge of the ribbon controller, press [UPPER].
10) While pressing down on the center of the ribbon controller, press [KEY MODE].
11) When the '*' appears on the display, press [UP].
12) Turn off the power of the JP-8000.
Roland JP-8000- Aide mémoire d'utilisation
42/169
Août 2015