Zanussi ZOA3572XMU Notice D'utilisation page 21

CLEANING THE DOOR GASKET
Regularly do a check of the door gasket. The door
gasket is around the frame of the oven cavity. Do
not use the oven if the door gasket is damaged.
Contact an Authorised Service Centre.
To clean the door gasket, refer to the general
information about cleaning.
REMOVING THE SHELF SUPPORTS /
CATALYTIC PANELS
To clean the oven, remove the shelf supports /
catalytic panels.
CAUTION! Be careful when you
remove the shelf supports. The
catalytic panels are not attached to the
oven walls and can fall out when you
remove the shelf supports.
1. Pull the front of the shelf support away from the
side wall. Hold the rear shelf runners and
catalytic panel in place with the other hand.
2. Pull the rear end of the shelf support away from
the side wall and remove it.
1
Install the removed accessories in the opposite
sequence.
The retaining pins on the telescopic
runners must point to the front.
CATALYTIC CLEANING
The cavity with a catalytic coating is self-cleaning. It
absorbs fat.
Before you turn on the catalytic cleaning:
• remove all the accessories .
• clean the oven floor with warm water and mild
detergent.
• clean the inner door glass with warm water and
soft cloth.
2
1. Set the function
2. Set the oven temperature to 250 °C and let the
oven operate for 1 hour.
3. Turn off the oven.
4. When the oven cools down, clean the cavity
with a wet soft cloth.
Spots or discolouration of the catalytic coating
have no effect on Catalytic cleaning.
REMOVING AND INSTALLING DOOR
The oven door has two glass panels. You can
remove the oven door and the internal glass panel
to clean it. Read the whole "Removing and
installing door" instruction before you remove the
glass panels.
The oven door may close if you try to
remove the internal glass panel before
you remove the oven door.
CAUTION! Do not use the oven
without the internal glass panel.
1. Open the door fully and hold both hinges.
2. Lift and turn the levers fully on both hinges.
.
21