Electrolux ERF3869SOW Notice D'utilisation page 35

Problem
The lamp does not work.
The compressor operates
continually.
There is too much frost
and ice.
The compressor does not
start immediately after
pressing the Shopping, or
after changing the temper‐
ature.
Water flows inside the re‐
frigerator.
Water flows on the floor.
Temperature cannot be
set.
Possible cause
The lamp is defective.
Temperature is set incor‐
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed
correctly.
The Shopping function is
switched on.
The door is not closed
correctly or the gasket is
deformed/dirty.
This is normal, no error
has occurred.
The water outlet is clog‐
ged.
Food products prevent
that water flows into the
water collector.
The melting water outlet
is not connected to the
evaporative tray above
the compressor.
The Shopping function is
switched on.
ENGLISH
Solution
Contact the nearest Author‐
ised Service Centre.
Refer to "Operation" chapter.
Wait some hours and then
check the temperature
again.
Refer to climate class chart
on the rating plate.
Allow food products to cool
to room temperature before
storing.
Refer to "Closing the door".
Refer to "Shopping function".
Refer to "Closing the door".
The compressor starts after
a period of time.
Clean the water outlet.
Make sure that food prod‐
ucts do not touch the rear
plate.
Attach the melting water out‐
let to the evaporative tray.
Switch off Shopping manual‐
ly, or wait until the function
resets automatically to set
the temperature. Refer to "
Shopping function".
35