Installation; Timer Setting; Maintenance / Cleaning; Disposal - Vortice ARIETT I Notice D'emploi Et D'entretien

ENGLISH
Caution:
!
this symbol indicates that care must
be taken to avoid damaging the appliance
• Do not make modifications of any kind to this
appliance.
• Do not expose this appliance to the weather (rain,
sun, etc.).
• Do not place objects on top of the appliance.
• Regularly inspect the appliance for visible defects. If
the appliance does not function correctly, do not use
it and contact Vortice immediately.
• If the appliance does not function correctly or
develops a fault, contact Vortice immediately and
ensure that only genuine original Vortice spares are
used for any repairs.
• Should the appliance be dropped or suffer a heavy
blow, have it checked immediately by Vortice
• The mains power supply to which the units are
connected must comply with current laws.
• The appliance is double insulated and therefore
does not need to be earthed
• The electrical power supply/socket to which the
appliance is to be connected must be able to provide
the maximum electrical power required by the
appliance
• Switch off the appliance at the installation's main
switch: a) if the appliance does not function correctly;
b) before cleaning the outside of the appliance, c) if
the appliance is not to be used for any length of time.
• Ensure that the room has an adequate source of
fresh air to ensure correct appliance operation. In
the event that other non-sealed combustion-based
appliances (such as water heater or gas stove) are
installed in the same room, check that air
replacement is sufficient for all appliances to work
effectively together.
• The appliance cannot be used to control activation
of water heaters, room heaters, etc. and it must not
exhaust into the hot air flues.
• Ensure that the appliance discharges into a single
duct (dedicated to this product) or directly to the
outside.
• The air to be extracted from the room must be clean
(i.e. free of grease, soot, chemical and corrosive
agents, and explosive or flammable mixtures).
• Do not cover or block appliance intake or outlet vents
grilles as this may prevent optimum air flow.
• T HCS Model: do not cover or obstruct the humidity
sensor grille.
An omnipolar switch with a
•
contact opening distance of 3
mm or higher
provided
enabling
disconnection under overvoltage
category III conditions.
Products equipped with single-
•
phase wiring
ALWAYS require connection to
220-240V (or only 230V where
8
should
for

installation,

complete
(M) engines
required) single-phase lines. Any
kind of modification shall be
considered
tampering and shall nullify the
relative warranty.
• Specifications for the power supply must correspond
to the electrical data on data plate A (Fig.A)
Installation
All models: fig. 1-21
Models I, I T : fig. 22-32 (false ceiling installation)

Timer setting

Fig. 33-42

Maintenance / Cleaning

Fig. 43-47

Disposal

This product complies with Directive 2012/19/EU on
the management of waste electrical and electronic
equipment (WEEE).
The crossed-out wheeled bin symbol
on the appliance indicates that, at the
end of its life, the product should not be
discarded together with household
waste but must be taken to a separate
collection point for electrical and
electronic equipment. This will avoid
negative effects on the environment and health, and
will encourage correct treatment, disposal and
recycling of the materials from which the product is
made.
Contact the municipal authority for the location of this
type of facility. Alternatively, the distributor is obliged to
take back the appliance to be disposed of free of
charge in exchange for the purchase of an equivalent
appliance.
be
as product