Kärcher BR 35/12 C Bp Manuel D'utilisation page 10

New & Reconditioned Equipment & Parts - www.southeasternequipment.net
Lift out the waste water tank and put

it aside.
Remove the lid from the fresh water

reservoir.
Fill in fresh water (maximum 50 °C).

Add detergent. Follow dosing in-

structions for detergent.
Recommended detergents:
Application
Regular cleaning
(even for floors sensi-
tive to alkalies)
Cleaning dirt from
grease
Basic cleaning (strip-
ping) of alkali-resis-
tant hard coatings
Basic cleaning (strip-
ping) linoleum
Base cleaner, acidic
Disinfection cleaning RM 732
Detergents are available in specialised
stores.
Close the cover of the fresh water

reservoir.
Place the waste water tank on the

appliance.
Release the star knob for the height

adjustment of the steering wheel.
Adjust the steering wheel to the de-

sired height.
Tighten the star handle.

Adjust the dosing of the cleaning so-

lution in accordance with the soiling
and the type of the flooring material.
Adjust the rotary handle of the

brush contact pressure to the de-
sired value.
10
Detergent
RM 745
RM 746
RM 69 ES
ASF
RM 69 ASF
RM 752
RM 754
RM 751
Settings
Only adjust the brush contact pressure
when the cleaning head is raised.
Note:
If the appliance pulls forwards too
strongly during operation, reduce the
contact pressure.
Bring the Eco mode switch into the

desired position.
Normal operation: The appliance
works at the maximum brush speed
and the highest suction performance.
Eco: The appliance works at re-
duced brush speed and suction
performance. This also reduces the
energy consumption. The possible
action time with one charging cycle
increases.
CAUTION
Risk of damage to the floor covering. Do
not operate the appliance on the spot.
Risk of damage. Lift the vacuum bar
before pulling the appliance backwards
over a longer distance.
Set the appliance switch to "I".

Switch on "Detergent" button.

Press the switch of the suction tur-

bine; the vacuum process will start.
Push down the pedal of the vacuum

bar lifting device at the back to low-
er the vacuum bar.
Pull the safety switch towards the

steering wheel, the brush drive and
the application of the cleaning solu-
tion are switched on (if preset).
Push the appliance forward until the

parking stand folds up and the
cleaning head touches the ground.
Move the appliance over the sur-

face to be cleaned.
Note:
If the steering wheel is turned by 180°,
the appliance also reverses.
– 8
EN
Cleaning