Important - Hoover POWERDASH GO Guide D'utilisation

How to Clean Carpets with your PowerDash
1
Plug power cord into
electrical outlet.
2
Press Red Button on
top of unit to turn ON.
For best results, pretreat stains with a HOOVER® spot treatment (see HOOVER® Cleaning Solution Guide) to help loosen
and remove even the most stubborn stains.
Distribute a generous amount of pretreat spray on spot, stain, or high traffic area.
Always follow specific directions found on solution label.
Wait 5-10 minutes before using machine.
Spot Cleaner
™
3
Spray a generous
amount of cleaning
solution over the soiled
area by pressing the
trigger behind the tool
and scrub the stain in a
back and forth motion.
4
To lift the stain,
suction up the dirt and
cleaning solution by
applying downward
pressure on the front of
the cleaning tool and
pulling towards you.
Repeat as needed.
*follow these steps for best results

IMPORTANT:

For full suction, it is important
that the Dirty Water Tank is properly secured before
cleaning.
CAUTION:
Do not clean over floor electrical
outlets. Water will drip from the tool after use and
may puddle. To avoid damage to wood and laminate
flooring and to avoid potential slip hazard, after use
(a) do not leave the product on wood and laminate
surfaces and move to a hard surface and (b) place
unit on an absorbent material (such as a towel) to
soak up drips.
Continue using dry strokes until little water is visible
passing through the nozzle.
For best results, HOOVER® recommends rinsing carpet
with water only. This removes residual carpet cleaning
solution. Fill Solution Tank with water and repeat. For
heavily soiled areas, repeat. Avoid saturating carpet.
NOTE: Empty Dirty Water Tank when the motor sound
becomes higher pitched and there is a loss in suction
(see "Automatic shut-off"). You will also see the float
rise and shut off suction at the same time.
9