GE RARWT Manuel Du Propriétaire Et Instructions D'installation page 15

Testing the Thermostat
Furnace Test
1. Toggle mode button until furnace mode is active. Furnace
mode screen is displayed.
2. Adjust set temperature so it is 5 degrees above room
temperature. Within a few seconds, the furnace should initiate
its startup procedure.
3. Adjust the set temperature so it is 2 degrees below the
room temperature and the heat should turn off. Note:
Depending on the model of furnace used, there may be a
delay in engaging and disengaging the furnace.
49-5000400 Rev. 5
15