Interruption Of The Descaling Process - Philips 2000 Série Mode D'emploi

7 Remove the drip tray, rinse it and place it back.
8 Reattach the classic milk frother.
9 Remove the water tank and rinse it.
10 Reinstall the Intenza+ water filter (if present).
11 Fill the water tank with fresh tap water up to the MAX indication
and slide the water tank back into the machine.
12 Press the on/off button to switch off the machine.
When you switch the machine back on, it is ready for use again.

Interruption of the descaling process

If the machine gets stuck in the descaling procedure, you can press
the on/off button.This allows you to complete the descaling
procedure. Follow the steps below to make sure your machine is
ready to brew coffee again.
1 Press the espresso button and regular coffee button
simultaneously for approximately 5 seconds.
2 Remove the drip tray, rinse it and place it back.
3 Remove the water tank and rinse it.
5 sec
4 Fill the water tank with fresh tap water up to the MAX indication
and slide the water tank back into the machine.
5 Press the espresso button and brew a cup of espresso. Repeat this
twice.
6 Turn the control dial to the hot water icon. Let hot water flow out of
the hot water/steam wand until the 'water tank empty light' lights
up continuously.
7 Remove the drip tray, rinse it and place it back.
8 Reattach the classic milk frother.
9 Remove the water tank and rinse it.
10 Reinstall the Intenza+ water filter (if present).
11 Fill the water tank with fresh tap water up to the MAX indication
and slide the water tank back into the machine.
12 Press the on/off button to switch off the machine.
When you switch the machine back on, it is ready for use again.
English
25