Installation Hardware And Accessory Details; Standard Window Installation - Friedrich Kühl KCS08 Manuel D'installation Et D'utilisation

Installation Hardware and Accessory Details

ITEM 1
ITEM 4
ITEM 7
ITEM 10 ITEM 11 ITEM 12
ITEMS NOT TO SCALE
Window Mount
Installation Hardware
ITEM DESCRIPTION QTY.
NO
WINGBOARD MOUNTING PARTS
8 WINGBOARD (MASONITE) 1
9 "J" TYPE SPEED NUT 4
10 WINGBOARD CLIP (SPRING STEEL) 4
11 SCREW, #8 x ½" PHILLIPS TRUSS HD. 4
WINDOW SEALING
12 WINDOW SEAL GASKET (DARK FOAM) 1
13 CHASSIS SEAL GASKET (LIGHT FOAM) 1
SHELL MOUNTING PARTS
1 SUPPORT BRACKET 2
2 SCREW, 10-24 x 1" HEX HEAD 4
3 10-24 FLAT WELD NUT 4
4 SCREW, SHEET METAL #12 x 2" 7
WINGBOARD ANGLE MOUNTING
5 WINGBOARD ANGLE, TOP 1
6 WINGBOARD ANGLE, SIDE 2
7 SCREW, SHEET METAL #8 x / " 2
3
8
28
ITEM 2
ITEM 3
ITEM 5 ITEM 6
ITEM 8 ITEM 9
ITEM 14
ITEM 13
FRR009
Thru-the-Wall
Installation Hardware
ITEM DESCRIPTION QTY.
NO
MOUNTING PARTS
4 SCREW, SHEET METAL #12A x 2" 7
14 CHASSIS SEAL GASKET (LIGHT FOAM) 1
NOTE: Kühl + models do not come with window mounting
components. When mounting a cooling and heating
model, a window installation kit must be purchased
separately.
KWIKS – For all KES and KH models.
KWIKM – For all KEM and KHM models.
KWIKL – For all KEL and KHL models.

Standard Window Installation

NOTE: Hardware and accessories used during installation are shown
on Page 28. Each part will be referred as "Item No."
STEP 1. Remove the chassis EntryGard retainer by removing the far
™
right screw (see Figure 54). Save this screw to reattach the
chassis retainer after installation (Step 12). Also, remove and
discard the two retainer screws and washer located at the rear
of the unit (see Figure 54).
CAUTION
Handle Use
Use handle on both sides to
Use Handle
pull unit from sleeve.
Locations
(both sides)
Do not push, pull, or lift from
center of support.
STEP 2. Hold the cabinet stationary. Then, use the hand grips on both
ends of the control unit support bracket to pull the chassis out of
the cabinet (see Figure 55).
STEP 3. Remove the large white foam blocks used to restrain the
compressor during shipment (see Figure 56). Inspect base pan
for dislodged white foam blocks and remove. Do not remove
any other foam parts.
Figure 54
FAR RIGHT
SCREW
Figure 55
CONTROL UNIT
SUPPORT BRACKET FRR012
STEP 4. Anchor the side angles (Item 6) by engaging the tabs of the
lower sill plate (see Figure 57, Detail B-2) with the loops of the
side angle. Engage the tabs of the top angle (Item 5) with the top
loops of the side angle (see Figure 57, Detail B-1). Install two (2)
screws (Item 7) to secure the top angle tabs and the side angle
to cabinet (see Figure 57, Detail B-1).
RETAINER SCREWS
AND WASHERS
ENTRYGARD
RETAINER
WIRE
FRR011
29