Fume Collecting Pipe; Brake Pump Oil - Bleeding The Brakes - Betamotor ALP4T 125 cc 2006 Mode D'emploi

3

FUME COLLECTING PIPE

A
Fume collecting tube A is located on the
left side of the vehicle next to the shock
absorber. It comes out of the lower part of
the filter box and is designed to collect the
fumes produced by the engine oil. It is de-
signed to collect the fumes produced by
the engine oil. Should any oil be found in
the tube, remove the cap at the lower end
of the tube and drain the oil, or the mixture
of oil and petrol, into a suitable container.
Disposal is to be made according to the
regulations in force.
Note
Empty the fume collecting tube every
3,000 km.
BRAKE PUMP OIL - BLEEDING THE
BRAKES
C
Front brake
Check that oil is present by looking
through oil level sight A. The minimum
oil level should never be lower than the
mark on sight A. To restore the oil level,
loosen the two screws B, lift cover C and
pour in fresh oil.
B
A
Rear brake
Check that oil is present by looking
through reservoir D. The oil level must
D
E
never be lower than the minimum level
mark on reservoir D. To restore the level,
remove filler cap E and top up with fresh
oil.
WARNING
A spongy feel of the brake lever may be
due to an air bubble in the braking sys-
tem. Immediately contact an authorized
workshop.
Note
For information on oil renewals, refer to
the table on page 142. Use the recom-
mended lubricants shown on page 123.
GB
131