Error Rectification - BWT bestaqua 14ROC Coffee Mode D'emploi

22

6.2 Error rectification

App screen
BWT
14ROC COFFEE
leakage
BWT
14ROC COFFEE
pump
cooling
BWT
14ROC COFFEE
no
water
BWT
14ROC COFFEE
009 18
uS C°
CONDUCTIVITY H 0 TEMP
2
7.8 186
bar
OUTLET PRESS DAYS
fault 0001
liter hours
INLET WATER PUMP ON
09852 090
liter liter/hour
OUTLET WATER OUTLET FLOW
info back
Flashing LEDs Error
Water leak in-
side the device
Inlet valve clos-
es automati-
cally.
Status LED turns
red and a warn-
ing signal sounds
Pump motor no
longer working
Status LED flashes
red once evenly
Pump motor no
longer working
The status LED
repeatedly flash-
es twice
The app shows
"fault" for inlet
water.
The device re-
mains in oper-
ation.
The status LED
repeatedly flash-
es three times
Cause Remedy
Leak or condensa- Disconnect device
tion inside the de- from electricity and
vice water supply
Check pump and
pipes, dry leak sensor
Motor overheat- The device will re-
ing protection trig- start automatically
gered when the motor has
cooled down.
If this error appears
after initial installation
and does not disap-
pear, please check
the electricity supply
to the booster pump.
No or insufficient Check pre-filter for
raw water input blockage and replace
if necessary
Check check valves,
open if necessary,
and check flow pres-
sure
4 bar)
Inlet water pres- Install pressure boost-
sure too low er if necessary
The inlet water Permeate is still pro-
meter is blocked duced but the inlet
or has no power water volume is not
supply. recorded.
Check power supply.
Replace inlet water
kit if necessary!
(RO working range: 1 to