De-Activate The "Programmed Weekly Switch On" Function; Energy Saving" Function; Preliminary Indications; Activate "Energy Saving" Function - GGM gastro POP434E Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 28

De-activate the "programmed weekly switch on" function

To de-activate the "programmed weekly switch on" function, operate as follows:
1. Ensure that no procedures are in progress.
2. Hold the "START/STOP" key pressed down for 1 s: the LED "DELAY" will go off.

"Energy Saving" function

Preliminary indications

The "energy saving" function enables reduction of the electrical absorption of the output of the top and bottom
elements of the oven, switching one on when the other is switched off.
The mode employed for carrying out the "energy saving" function will trigger an automatic adjustment of the power
supplied to the bottom element so that it guarantees that the sum of the power supplied to the top and the power
supplied to the bottom is 100 (e.g.: top 70 + bottom 30 = 100).

Activate "energy saving" function

To activate the "energy saving" function, operate as follows:
1. Ensure that the appliance is not switched off, that no other procedure is in progress and that the "rapid
heating" function is not in progress
2. Press and release the "INCREASE" key: the LED
the key is pressed and released again or after a maximum of 2 hours)
If the appliance is switched off when the "energy saving" function is in progress, the next time the appliance is
switched on the function will not be brought back up, if the power supply is interrupted when the function is in
progress, on restoration of the supply the function will be brought back up for a 2 hour period, if not switched off
manually via the "INCREASE" key.

6 MODE OF USE

Functional tests

Before switching the oven on check:
You have removed the protective film, if provided;
The plug is properly inserted into the power supply wall socket;
That the system supply voltage, frequency and power are compatible with the values provided on the label
affixed on the right side of the oven;

Oven switch on

To switch on the POWER PIZZA oven proceed as follows:
Turn the general switch to position 1;
Press the "SWITCH ON/OFF" key to switch the display on;
Set the desired temperature on the Thermostat (UPPER display);
Set the power percentage of the Top and the Bottom elements of the oven (LOWER display);
Set cooking timer (cooking cycle);

First oven switch on

The first time the appliance is used it is recommended to heat the oven when empty to eliminate bad smells caused by the
evaporation of moisture content of the refractory stones, in the insulating material and the metallic parts inside.
Follow the procedure below:
Close all the doors and open the vent valves to maximum opening;
Set the temperature to 150° C;
Set the percentage of the top and bottom elements to 100%;
Set the cooking timer to 8;00 hours.
will switch on and the function will be activated (until
72

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Pop634ePop934ePop434edPop634edPop934ed

Table des Matières