Programmed Weekly Switch On; Preliminary Indications; Set The Day And Time Of Switch On And The Programme To Start Up - GGM gastro POP434E Mode D'emploi

Programmed weekly switch on

Preliminary indications

The "programmed weekly switch on" enables the appliance to be programmed to switch on and to start a programme
up at the same time, see chapter "Set cooking programmes".
The function must be activated with the procedure illustrated in the paragraph "Activation of the programmed
weekly switch on function".
Starting up the cooking cycle must be triggered by pressing and releasing the "START/STOP" key.
If the r12 parameter is set to 0, the "programmed weekly switch on" function will not be available.

Set the day and time of switch on and the programme to start up

The day of switch on is shown in the format 1... 7
(number 1 corresponds to Monday), the time is displayed in 24 hour format (hours:minutes).
To set the day of switch on, operate as follows:
1. Ensure that parameter r12 is set to 1, that some
programmes have been used, that the appliance is
switched off and that no other procedure is in
progress.
2. Hold the "PROGRAMMES" key pressed down for 1
s: the LED "DELAY" will switch on and the bottom of
the "UPPER" display will show the value of the day
of switch on; the day will flash.
If no switch on time is set, the bottom of the
"UPPER" display will only show the day of switch
on.
3. Press and release the "INCREASE" key or the
"DECREASE" key within 15 s to set the day.
To set the programme to start up, operate as follows:
4. Press and release the "PROGRAMMES" key when
setting the day of switch on: the bottom of the
"LOWER" display will show the number of the first
programme used; the programme number will flash.
If no other programme is used, the bottom of the "LOWER"
display will show "-" flashing.
5. Press and release the "INCREASE" or
"DECREASE" key within 15 s to select the
programme number.
To set the time of switch on, operate as follows:
6. To set the hour, press and release the "PROGRAMMES" key when setting the programme to start up: the
hours value will flash.
7. Press and release the "INCREASE" key or the "DECREASE" key within 15 s to set the hour.
8. To set the minutes, press and release the "PROGRAMMES" key when setting the hours: the minutes
value will flash.
9. Press and release the "INCREASE" or the "DECREASE" key within 15 s to set the minutes.
70