The Elements/Setting The Controls; Radiant Elements; Single Element; Dual Element - Bosch NES Manuel D'utilisation Et D'entretien

NES Cooktop Use and Care Manual
The Elements / Setting the Controls

Radiant Elements

Bosch UltraSpeed radiant elements use a wire
TM
ribbon located under the ceramic glass surface
to provide the heat for cooking. These radiant
elements will cycle on and off by design (see
Temperature Limiters, below.) There are 9 heat
setting positions from 9 (high) to 1 (low) and a
special setting for keep warm.

Dual Element

The dual element consists of two radiant ribbon
elements within the same heating area. Either the
small inner element or both the inner inner element or both the
elements may be selected for use, depending on
the size of cookware. (See page 7.)

Temperature Limiters

Each UltraSpeed heating element has its own
sensor to protect the glass cooking surface from
extreme high temperatures. The limiters will
operate automatically by cycling the element on
and off regardless of the cook setting.
Although cycling is normal, any one of the following
conditions can activate the limiter and cause it to
cycle on and off more than usual:
• The base of the pan is not making full contact
with the heating surface (due to a warped or
uneven base).
• The pan is too small for the size of the
element.
• The pan has boiled dry.
• The material or shape of the pan is slow to
transfer the heat.
Setting the Controls (dual element)
1. Place pan on element.
2. Touch element pad for desired element.
Display will show a 0.
3. Touch POT SIZING pad. Control defaults
to large size (inner and outer) element. Touch
the POT SIZING element pad again for smaller
element. Touching the POT SIZING pad
repeatedly alternates the element size. The
dual element light comes on above element pad
when using large element.
4. Turn the mTwisT dial to the desired setting.
To the right (clockwise) starts with heat
setting 1 (low).
To the left (counterclockwise) starts with heat
setting 9 (high).
Turn the dial until the desired heat setting is
displayed.
Setting the Controls (single element)
1. Follow steps 1, 2 and 4 above.
Changing Heat Setting While Cooking
inner and outer
1. Touch element pad for element desired. Display
will show 0.
2. Turn dial. The fi rst turn of the mTwisT dial will
display the current cook setting.
3. Turn dial left or right to new cook setting. The
new cook setting is displayed.
Change Pot Size when Cooking (for dual
only)
See Pot Sizing (Page 6 ).
To Turn Off One Surface Element
1. Touch element pad for desired element.
2. Display shows 0. After 5 seconds the element
shuts off.
the element turns off.
To Turn Off All Elements at the Same Time
1. Touch POWER OFF pad.
removed, the cooktop controls are locked.
Replace mTwisT dial then touch and hold PANEL
LOCK pad for three seconds to unlock control.
PAGE 5
Cooktop Operating Instructions
Or
touch element pad twice.
Or
touch element pad once. After fi ve seconds,
Or
Remove mTwisT dial from cooktop. Once