Changing The Battery; Charging The Battery - Renkforce 1384136 Mode D'emploi

Mounting
Refer to the information in "Preparation for mounting".
When drilling mounting holes or tightening screws, ensure that no cables or pipes
(including water pipes) are damaged.
1
2
3

Charging the battery

The built-in battery is charged via solar power. Before using the outdoor wall lamp for the first time,
leave it turned off in direct sunlight for two days to allow it to charge.
Operation
On/off
• Unscrew the two side screws using a
screwdriver and then remove the wall
mounting clamp from the outdoor lamp housing
by pulling outwards.
• Use the wall mounting clamp as a template to
mark the fixing points on the mounting surface.
Pay attention to the orientation of the outdoor
lamp housing.
• Drill two holes for the dowels into the mounting
surface. (If you are using a wooden surface,
you can directly screw the wall mounting
clamp to the surface. However, you should still
drill holes even when using wood. The dowels
are not required in this case.)
• Insert the dowels into the drilled holes.
• Secure the wall mounting clamp to the
mounting surface using the screws provided.
• Place the outdoor wall lamp back onto the wall
mounting clamp to secure it to the wall.
• Fix the outdoor wall lamp onto the wall
mounting clamp using the side screws that you
previously removed.
• Before using the outdoor wall lamp, remove the
base by turning it in an anticlockwise direction.
Turn on the switch on the bottom of the lamp.
Replace the base and secure it in place by
turning it in a clockwise direction.
• When you have finished using the wall lamp,
follow the steps above to remove the base and
then turn off the switch.
• The twilight switch turns the lamp on as soon
as the ambient brightness drops to (or below) a
certain value. When it gets brighter again, the
lamp turns off.

Changing the battery

Replace the rechargeable battery with a battery of the same type and capacity (see "Technical
data") if there is a noticeable drop in the lamp's brightness when it has only been turned on for a
short period.
1
2
3
4
• Remove the base by turning it in an anticlockwise
direction.
• Remove the upper part of the outdoor wall lamp
from the housing.
• Separate the base plate from the upper part of
the lamp by removing the two screws with a
screwdriver. Ensure that you do not damage the
cables in either part.
• Remove the two battery clamps and remove the
used/defective battery.
• Insert a new rechargeable battery of the same type
into the battery compartment, paying attention to
the polarity markings (plus/+ and minus/-).
• Fix the battery in place using the two battery
clamps.
• Connect the upper part of the outdoor wall lamp to
the base plate again.
• Place the upper part of the outdoor wall lamp into
the housing.
• Replace the base and turn in a clockwise direction
to secure.