Faults; Acceptance Of The Centrifuges For Repair - Hettich ROTINA 35 Mode D'emploi

EN
23

Faults

If the error is not able to be eliminated according to the fault chart, and if the error message appears once again in
the display after MAINS-RESET, the Hettich Customer Service Department is to be notified.
Please state the type of centrifuge and the factory serial number. Both values are visible on the centrifuge type plate.
MAINS RESET: - Mains switch OFF for longer than 10 secs.
- Mains switch ON.
Message / fault
No display
TACHO - ERROR
IMBALANCE
CONTROL - ERROR
06 - 09
N > MAX
N < MIN
ROTORCODE
MAINS INTERRUPT
VERSIONS-ERROR
CONTROL-ERROR 21 - 27
SER I/O - ERROR 30 - 38
° C * - ERROR 50 - 56
LOCK - ERROR
FU / CCI - ERROR 60 - 83
N > ROTOR-MAX
24

Acceptance of the centrifuges for repair

If the centrifuge is returned to the manufacturer for repair, it must be decontaminated and cleaned to protect persons,
environment and material.
We reserve the right to accept contaminated centrifuges.
Costs incurred for cleaning and disinfection are to be charged to the customer.
We ask for your understanding in this matter.
You will find further information on our homepage: http://www.HettichLab.com
18/56
Cause
--- − No voltage.
− Overvoltage protection tripped out.
01 − Faulty speedometer.
02 − No rotor installed.
− Defective motor, frequency converter or
drive.
--- Imbalance about motor axis through weight
differential in rotor assembly.
04, Error in lid locking or lid closure.
05 Rotation too fast
13 Rotation too slow
10 Incorrect rotor coding
--- Power failure, centrifuging not properly
completed
12 Mismatch between electronic components
Error / defective control unit
Error / defective interface
Error / defective cooling
57 Error / defective program locking
Error / defective motor control
--- Speed in the selected program greater than
the maximum speed of the rotor.
Remedy
− Check supply voltage.
− Mains switch ON.
− Open lid.
− Turn rotor manually.
− MAINS-RESET when power is
switched on, rotor should turn.
− Open lid.
− Correct imbalance.
− Open lid.
− MAINS-RESET
− Open lid.
− Push
button.
START
− Open lid.
− MAINS-RESET
− Check the set speed.
Reduce the set speed