Safety Instructions; Proper Use; Technical Data; Before Starting The Equipment - EINHELL CC-TJ 2000 Mode D'emploi D'origine

Anleitung_CC_TJ_2000_SPK1__ 16.02.2017 14:46 Seite 7
m
Important!
When using the equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating instructions and
safety regulations with due care. Keep this manual in
a safe place, so that the information is available at all
times. If you give the equipment to any other person,
hand over these operating instructions and safety
regulations as well. We cannot accept any liability for
damage or accidents which arise due to a failure to
follow these instructions and the safety instructions.

1. Safety instructions

Before you raise the load, check that the lowering
n
screw is tightly shut.
Always place the hydraulic trolley jack on firm and
n
level ground when using it to raise a load.
Never work underneath a raised load which is
n
supported only by the hydraulic trolley jack.
Working on and under raised vehicles is only
permitted when the vehicle in question is secured
and supported against tipping and slipping.
The trolley jack is designed only for raising loads.
n
After a load is raised it must be supported
immediately by at least one jack stand. Vehicles
must be sufficiently secured against rolling before
they are raised with the trolley jack. Never use the
trolley jack at an angle.
Position the trolley jack only where specified by
n
the vehicle manufacturer.
Make sure that no one leans against a raised
n
vehicle or load.
It must be possible for the operator to observe the
n
lifting equipment and the load during all
movements.
The equipment markings must be checked to
n
ensure that the original condition is maintained.
The lifting equipment is not allowed to be
n
modified in any way which could have a negative
impact on the lifting equipment's compliance with
this standard (EN 1494).
2. Layout (Fig. 1)
1. Drain screw
2. Piston rod mount
3. Carry-handle
4. Lifting arm
5. Support plate
6. Roller
7. Guide roller
8. Jack handle

3. Proper use

The hydraulic car jacks comply with EN1494: 2009-
05. They are designed for lifting loads, preferably
cars, at an ambient temperature of -20°C to +50°C.
The machine is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the manufacturer
will be liable for any damage or injuries of any kind
caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.

4. Technical data

Lifting (load) capacity (kg):
Minimum height (mm):
Lift (mm):

5. Before starting the equipment

Air pockets may form in the hydraulic fluid passages if
the jack is not used for a long time or if there is too
little fluid in the hydraulic system from the outset.
In both cases, proceed as follows:
a) Topping up with oil (Fig. 2)
Remove the cover plate. On the hydraulic cylinder you
will see a rubber plug in the fluid filler hole. With the
trolley jack in horizontal position on the floor, remove
the rubber plug by pressing it in on the side with a
screwdriver. Fill in hydraulic fluid (type: HLP 32 Iso or
equivalent) through the fluid filler hole.
You must fill in enough fluid to cover the cylinder
GB
2000
135
170
7