Safety Instructions; Proper Use; Technical Data; Before Starting The Equipment - EINHELL BT-TJ 2250 Mode D'emploi D'origine

Anleitung_BT_TJ_2250_SPK1__ 13.01.15 07:05 Seite 7
Important!
When using the equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating instructions and
safety regulations with due care. Keep this manual in
a safe place, so that the information is available at all
times. If you give the equipment to any other person,
hand over these operating instructions and safety
regulations as well. We cannot accept any liability for
damage or accidents which arise due to a failure to
follow these instructions and the safety instructions.

1. Safety instructions

Before you raise the load, check that the
lowering screw is tightly shut.
Always place the hydraulic trolley jack on firm
and level ground when using it to raise a load.
Never work underneath a raised load which is
supported only by the hydraulic trolley jack.
Working on and under raised vehicles is only
permitted when the vehicle in question is
secured and supported against tipping and
slipping.
The trolley jack is designed only for raising loads.
After a load is raised it must be supported
immediately by at least one jack stand. Vehicles
must be sufficiently secured against rolling
before they are raised with the trolley jack. Never
use the trolley jack at an angle.
Position the trolley jack only where specified by
the vehicle manufacturer.
Make sure that no one leans against a raised
vehicle or load.
It must be possible for the operator to observe the
lifting equipment and the load during all
movements.
The equipment markings must be checked to
ensure that the original condition is maintained.
The lifting equipment is not allowed to be
modified in any way which could have a negative
impact on the lifting equipment's compliance with
this standard (EN 1494).
2. Layout (Fig. 1)
1. Drain screw
2. Piston rod mount
4. Lifting arm
5. Support plate
6. Roller
7. Guide roller
8. Jack handle

3. Proper use

The hydraulic car jacks comply with
EN1494/A1 : 2008. They are designed for lifting loads,
preferably cars, at an ambient temperature of -20°C to
+50°C.
The machine is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.

4. Technical data

Lifting (load) capacity (kg):
Minimum height (mm):
Lift (mm):

5. Before starting the equipment

Screw together the 2-piece retention bar.
Air pockets may form in the hydraulic fluid passages
if the jack is not used for a long time or if there is too
little fluid in the hydraulic system from the outset.
In both cases, proceed as follows:
a) Topping up with oil (Fig. 2)
On the hydraulic cylinder you will see a rubber plug
in the fluid filler hole. With the trolley jack in
horizontal position on the floor, remove the rubber
plug by pressing it in on the side with a screwdriver.
Fill in hydraulic fluid (type: HLP 32 Iso or equivalent)
through the fluid filler hole.
GB
2250
140
380
7