Festool DOMINO DF 500 Q Notice D'utilisation D'origine/Liste De Pièces De Rechange page 17

Fault
B5 dowel hole not parallel
to workpiece edge
B6 dowel hole not at right
angles (90°) to work-
piece surface
9a, The position of the
9b dowel holes, which
were created with the
left and right stop latch,
does not exactly match
(different distance to
workpiece edge).
Cause
workpiece has shifted during
processing
a) deposits (e.g. chips) below the
base plate
b) angle guide not set exactly to 90°
c) worked on without angle bracket
The midpoint between the two
stop latch is not exactly in the
midpoint of the swivel range of
the jointer bit.
17
Adjustment
secure workpiece properly
a) remove deposits
b) set angle guide to 90° exactly
c) use angle bracket
Remove one of the stop latches
(9.1) (Fig. 9a). Attach one of
the accompanying stop latches
(9.2) to the dowel jointer (Fig.
9b).These stop latches are nar-
rower and allow you to make
more accurate adjustments.