Technical Specifications - Chicco 06626 Mode D'emploi

panel upward (fig.3).
Remove the 4 1.5V Alkaline AA/LR6
batteries and replace them with 4
similar batteries, taking care to re-
spect the proper insertion polarity as
indicated in the battery compartment.
Reposition the Alkaline battery com-
partment closing panel (10) first in-
serting the lower panel hooks in their
battery compartment housing and
gently pushing the panel downward
(fig.4).
3.3 Installing the lithium-ion battery
supplied with the parent unit (pri-
marily in receiver mode)
Upon purchase, the 3.7 V 1800mAh
rechargeable lithium-ion battery (13)
in the parent unit is kept separately in
the product packaging.
Carefully remove the lithium-ion bat-
tery from its packaging.
Remove the rechargeable battery
compartment closing panel (10), plac-
ing your finger near the top groove
and gently pulling the panel outward
(fig.5).
Insert the lithium-ion battery (13), re-
specting the proper insertion polarity
as indicated in the battery compart-
ment.
Reposition the rechargeable battery
compartment closing panel (13), first
inserting the lower panel hooks in
their battery compartment housing
and gently pushing the panel toward
the product (fig.6).
3.4 Replacing the lithium-ion bat-
tery supplied with the parent unit
(primarily in receiver mode)
If the duration of the rechargeable
lithium-ion battery is reduced exces-
sively, this means that it has run out
and therefore must be replaced (this
is to be considered normal because
rechargeable batteries run out over
time).
Remove the rechargeable battery
compartment closing panel (10), plac-
ing your finger near the top groove
and gently pulling the panel outward
(fig.7).
Remove the run out rechargeable bat-
tery (13) and replace with another
rechargeable battery that is identical
to the 3.7V 1800mAh supplied with
the product (code20256600100 to
be requested directly from Artsana
S.p.A.) taking care to place them with
the correct insertion polarity indicated
on the battery compartment.
Reposition the rechargeable battery
compartment closing panel (10), first
inserting the lower panel hooks in
their battery compartment housing
and gently pushing the panel toward
the product (fig.8).

TECHNICAL SPECIFICATIONS

Baby unit (primarily in transmitter
mode of images and sounds)
Mod. 06626
Power:
Internal: FOUR 1.5V AA/LR6 ALKA-
LINE BATTERIES
External: via 100-240V~
/6.5V 550mA mains switch-
ing adapter
Transmission:
• Transmission frequency band: 2400-
2454MHz
• Signal strength: 100mW max
LED infrared radiation: emissions be-
low LEA Class 1, standard EN 60825-1
38
50/60Hz