Chicco 06626 Mode D'emploi page 40

TROUBLESHOOTING
If you experience problems, please first check the following list and check that:
• Both units are on
• Both units are properly connected to the power socket via the mains adapter (1),
or that batteries are charged.
FAULT
Parent - Baby unit (transmitter)
unit (re- and/or parent unit (re-
ceiver)/ ceiver) off.
Baby - Baby unit Alkaline bat-
unit teries (not included) and/
(trans- or parent unit lithium-ion
mitter) battery completely dis-
power charged.
and link - Mains adapter discon-
indicator nected or not connected
(8) off correctly.
- No mains voltage.
The - No discernible sounds
parent are arriving to the Baby
unit (re- unit (transmitter).
ceiver) - The voice activation func-
does not tion has been selected.
emit any - Parent unit (receiver)
sounds volume set at minimum.
- Baby unit Alkaline bat-
teries and/or parent unit
lithium-ion battery com-
pletely.
- The parent unit (receiver)
may be off.
CAUSE
- If necessary, switch on the Baby unit
(transmitter) and/or the parent unit
(receiver).
- Replace Alkaline batteries in the Baby
unit and/or charge rechargeable lithium-
ion battery in the parent unit
- If the units are powered via mains
adapter, verify that this device is cor-
rectly connected to a mains outlet.
- Check that the outlet is being powered.
- Just as soon as discernible sounds from
the environment are present, the trans-
mitter will be activated. In any case, for
peace of mind, test transmission with the
help of another person who can try to
speak in the room the Baby unit (trans-
mitter) is on.
- If the display shows the
selector is set to ON, the voice activation
function is active.
As soon as sounds present in the Baby
unit environment exceed the threshold
for voice activation, the parent unit will
emit sounds.
- Adjust the volume on the parent unit
(receiver) until sounds are audible by
pressing the + volume adjustment but-
ton (5a).
- Replace in the Baby unit Alkaline bat-
teries and/or charge lithium-ion battery
in the parent unit
- Switch on the parent unit (receiver).
40
SOLUTION
icon and