Nightlight - Chicco 06626 Mode D'emploi

Voice Activation Function ac- Voice Activation Function ac-
tive
Minimum volume level
Maximum volume level
Rechargeable battery charged
Medium charging level on re-
chargeable battery
Low charging level on recharge-
able battery
Rechargeable battery flat: the
parent unit will switch off with-
in a few minutes
2. Description of features
2 Baby unit (primarily in transmitter
mode of images and sounds)
2.1.1 Power:
Power via 100-240V~, 50/60Hz /6.5V
, 550mA (1) mains switching
adapter or via 4 1.5V AA /LR6 Alkaline
batteries (not included).
When power is supplied with mains
adapter (1):
- verify that the voltage corresponds
to the rating plate of the previously
indicated adapters.
- insert the mains adapter jack (1) in
the power connector (11) on the side
of the unit.
- insert the mains adapter plug in an
easily accessible power socket.
ATTENTION:
- The adapter cord may constitute a
risk of strangulation, keep out of reach
of children.
- Periodically inspect mains adapters
(1). If the power cord or plastic parts
show signs of damage, do not use
them and contact a qualified techni-
cian.
- Do not leave mains adapters (1)
plugged into the outlet when devices
are not in use and/or not connected to
the mains adapters (1).
2.1.2 Modes of use - Switching on and
Adjustment
The Baby unit (primarily in transmitter
mode of images and sounds) must be
positioned about 1 - 1.5 metres from
the child, on a flat, stable surface and
with the microphone (5) and the cam-
era lens (5) directed toward the child.
Attention: the Baby unit, mains
adapter (1) and its power cord must be
kept out of reach of children.
Switching the Baby unit on/off
Press the on/off button (2) for about
2 second. The Baby unit (primar-
ily in transmitter mode of images and
sounds) will switch on.
The power and link indicator light (9)
will begin to flash green to indicate
that the Baby unit is searching for a
connection to start audio transmis-
sion with the parent unit. Once con-
nection has been established between
the 2 units, the power and link indica-
tor light will light up steady green.
Keep the button (2) pressed for 2 sec-
onds. The power and link indicator (9)
and the Baby unit (primarily in trans-
mitter mode of images and sounds)
will switch off.

Nightlight

A night light (4) is present on the Baby
unit.
The nightlight can be set with a dual
function: nightlight at minimum in-
31