Chicco 06626 Mode D'emploi page 37

sunlight.
- Do not expose lithium batteries to
mechanical shock. In case of acciden-
tal falls, always check the status of the
container and contacts before pro-
ceeding with re-use. Do not use if the
lithium battery is damaged as a result
of the fall.
- In the case of liquid leakage from the
battery, be careful to avoid contact
with skin and eyes with the liquid. If
contact occurs, wash affected areas
with plenty of water and seek medi-
cal advice.
- Do not use any charger not specifi-
cally provided for use with the equip-
ment.
- Observe the markings (+) and (-) on
the Lithium battery and on the prod-
uct to ensure proper insertion and use.
- Do not use a lithium battery differ-
ent from that supplied to power the
device.
- Keep Lithium batteries away from
the reach of children.
- This device has been designed to pre-
vent and inhibit the incorrect insertion
of the lithium battery: always observe
the relative polarity markings on the
product and on the Lithium battery to
ensure proper use.
- Do not use a model of battery that
is different than that stated in this
instruction manual in the device. The
battery purchase reference code is
COD.20256600100
- Recharge the lithium battery only
under application and only us-
ing the mains adapter supplied
(COD.20256600200). Do not re-
charge the lithium battery using an
external battery charger. Follow the
instructions in this manual to recharge
the lithium battery.
- Keep the battery and the battery
contacts clean and dry. In the event
that the contacts become dirty, clean
the terminals with a soft, dry cloth.
Do not use abrasives, chemicals or
solvents to clean the battery and its
contacts.
- Lithium batteries require charging
prior to use. Always refer to the in-
structions for correct charging proce-
dures.
- Do not keep charging the lithium
battery when not in use.
- Always remove the Lithium battery
from the product when not in use.
- Dispose of properly according to the
information in this manual.
3.1 Installing Alkaline batteries not
included in the Baby unit (primarily
in transmitter mode of images and
sounds)
Remove the Alkaline battery compart-
ment closing panel placing your finger
near the arrow and gently pulling the
panel upward (fig.1).
Insert 4 1.5V Alkaline AA/LR6 batter-
ies, respecting the proper insertion
polarity as indicated in the battery
compartment.
Reposition the Alkaline battery com-
partment closing panel (10) first in-
serting the lower panel hooks in their
battery compartment housing and
gently pushing the panel downward
(fig.2).
3.2 Replacing Alkaline batteries not
included in the Baby unit (primarily
in transmitter mode of images and
sounds)
Remove the Alkaline battery compart-
ment closing panel placing your finger
near the arrow and gently pulling the
37