Setting The Clock - Askoll eSpro K1 Mode D'emploi

Setting the clock

• Press and hold the SELECT button for about 2
seconds: the two digits corresponding to the time
will start flashing.
• Press SELECT repeatedly to set the correct time.
• Press the SET button: the minute digits will start
flashing and the hour digits will return to fixed.
• Press SELECT repeatedly to set the correct
minutes.
• Press the SET button to exit the setting.
Since time is stored in the vehicle battery, in case of
two batteries, it is convenient to set the clock with both
batteries installed to synchronize time. In any case, if
there are two batteries, the time stored for the battery
in compartment A is always displayed.
For battery description
compartments A and B refer to chapter "BATTERY
AND RECHARGE".
eSpro K Rev03 - EN.indb 27 eSpro K Rev03 - EN.indb 27
A
SELECT
and positioning in
Km/trip
PWR
%
SET
USE
EN
EN
EN
EN
EN
27
17/11/2020 11:01:37 17/11/2020 11:01:37