Preparing The Units - Bosch HUI54451UC Instructions D'installation

Preparing the units

Fitted units must be heat-resistant up to 90 °C. The
stability of the fitted unit must also be guaranteed after
the cut-out work.
Make the cut-out according to the installation sketch.
After the cutting out work is complete, remove the
shavings.
Notes
Heed the clearance between the partition floor and the
▯
lower edge of the fitted unit; see drawing.
Use the included template to make the holes and the
▯
cut-outs.
Attach the template to the lower side of the partition
1.
floor. Drill holes.
Make cut-out for the exhaust air pipe:
2.
Exhaust air opening above the fitted unit:
Exhaust air opening behind the fitted unit:
11