Setting The Scan Resolution; Setting The Scan Mode; Scanning - SilverCrest SHM 600 A1 Mode D'emploi

Handling and operation

Setting the Scan Resolution

♦ Press the button DPI
resolution (HIGH = 600 dpi) or the low resolution (300 dpi =
LOW). In the display

Setting the Scan Mode

♦ Press the button C/BW
mode (COLOR) or the black / white mode (MONO). In the
display

Scanning

NOTICE
► To scan, please ensure that the appliance is not connected
to a computer and the Micro-SD memory card is inserted.
♦ Switch the appliance on with the button /SCAN
♦ Place the document on a fl at surface and hold it down fi rmly
with one hand.
♦ Place the appliance on the edge of the paper. Ensure that the
scan area between the markings for the scan width (
which are marked on the side of the appliance, is maintained.
♦ Hold the appliance pressed fl at against the document and press
the button /SCAN
♦ Proceed slowly with the appliance over the document whilst
keeping your hand steady, so as to achieve the best quality for
the scanned document.
♦ Press the button /SCAN
NOTICE
► To conserve the batteries, the appliance switches off auto-
matically after 3 minutes of not being in use.
SHM 600 A1
to choose between either the high
either HIGH or LOW is indicated.
to choose between either the colour
either COLOR or MONO is indicated.
once. The LED SCAN
once again to stop scanning.
.
),
glows.
71
GB