Other Features - Beko BA309C Manuel De L'utilisateur

5 Operation

5.2 Other features

Zone follow
Note: This feature can be activated from the remote control only. The remote control
serves as a remote thermostat allowing for the precise temperature control at its
C
location. To activate the Zone Follow feature, point the remote control towards the
unit and press the Zone Follow The remote control will send this signal to the air
conditioner until press the Zone Follow again. If the unit does not receive the Zone
Follow/Temp Sensing signal during any 7 minutes interval, the unit will exit the Zone
Follow/Temp Sensing mode.
C
Note: This feature is unavailabe under Fan or Dry mode.
Auto-Restart
If the unit breaks off unexpectedly due to the power cut, it will restart with the previous function
setting automatically when the power resumes.
Air flow direction adjustment
The louver can be adjusted automatically. Adjust the air flow direction automatically:
- When the power is on, the louver opens fully.
- Press the SWING button on the panel or remote controller to initiate the Auto swing feature.
The louver will! swing up and down automatically.
- Please do not adjust the louver manually.
Wait 3 minutes before resuming operation
After the unit has stopped, it can not be restarted operation in the first 3 minutes. This is to protect
the unit. Operation will automatically start after 3 minutes.
Power management feature (on some models)
When the ambient temperature is lower than the setting temperature for a period of time, the unit
will be automatically operate power management feature. The compressor and fan motor stop.
When the ambient temperature is higher than the setting temperature, the unit will be automatically
quit the power management feature. The compressor and (or) fan motor run.
C
Note: For unit with power management light, the light will illuminate under this
feature.
36 / 276 EN
Local air conditioner / Instruction Manual