Cab And Roll Bar - GOLDONI Star Série Manuel D'emploi Et Entretien

Controlled draught
Ideal to maintain constant the draught force required from the tractor and thus
prevent engine overload and ensure that wheel slippage is within very low levels
(ploughs, rotary cultivators, etc.).
• Move lever n.15 fig.1 all the way back.
• Use lever n.14 fig.1 to raise and lower the lift.
Floating mode
Ideal when you want to leave the implement free to follow the contour of the
ground (cultivators, ridgers, scrapers, etc.).
• Move lever n.14 fig.1 all the way back.
• Use lever n.15 fig.1 to raise and lower the lift.
Combined setting
Ideal when you want to prevent the implement from lifting out more than a certain
set height.
• Use lever n.15 fig.1 to raise the lift to the required height.
• Raise and lower the lift with lever n.14 fig.1.
Regulating lift rate and sensitivity
Slacken off completely regulating screw n.16 fig.1, under the seat to lock the
implement in its raised position. This is a safety device when implements are
transported on road.
Screw out this regulator to increase lift lowering speed.
Turn regulator n.17 fig.1 clockwise to increase 3-point hitch sensitivity.
3-point hitch sensitivity can be further increases by attaching it to one of the
lower tractor hitch holes.
The 3-point hitch must NOT be used to tow implements.

5. CAB AND ROLL BAR

(optional)
- For Italy
If the cab and roll bar are retro-fitted, the customer should ask our Sales
Organisation for the requisite Certificates of Approval.
With these certificates and the Logbook or Tractor Registration book, the
customer can then apply to the nearest Ministry of Transport Test Centre for the
necessary procedures to update or replace the Logbook.
- For other countries
If the cab and roll bar are retro fitted, the customer should check with the
74