Ricoh MPC 2800 AT-C2 Mode D'emploi page 686

8. Appendix: SP Mode Tables
RFU Timing
Selects the timing for the remote firmware updating.
013
[0 or 1 / 1 / – ]
0: Any status of a target machine
1: Sleep or panel off mode only
RCG – C Registed
This SP displays the RCG-N installation end flag.
021
0: Installation not completed
1: Installation completed
RCG – C Registed Detail
This SP displays the RCG device installation status.
022
0: RCG device not registered
1: RCG device registered
2: Device registered
Connect Type (N/M)
This SP displays and selects the RCG-N connection method.
8
023
[0 or 1 / 0 / 1 /step
0: Internet connection
1: Dial-up connection
061 Cert. Expire Timing DFU
062 Use Proxy
Proxy Host
This SP sets the address of the proxy server used for communication between the RCG
device and the gateway. Use this SP to set up or display the customer proxy server address.
The address is necessary to set up the embedded RCG-N.
063
• The address display is limited to 128 characters. Characters beyond the 128
• This address is customer information and is not printed in the SMC report.
318
Proximity of the expiration of the certification.
This SP setting determines if the proxy server is used when
the machine communicates with the service center.
character are ignored.