Ricoh MPC 2800 AT-C2 Mode D'emploi page 512

8. Appendix: SP Mode Tables
Specifies the threshold of the pressure roller for the paper feed to the 1bin tray in 1200 dpi
mode.
1105 [Fusing Temperature] Fusing Temperature Adjustment
(Printing Mode, Roller Type, [Color], Simplex/Duplex)
Roller Type –> Center and Ends: Heating roller,
Pressure –> Pressure roller
Paper Type -> Plain, Thin, Thick, OHP, Middle Thick, Special
Fusing Ready Temp.
001
Specifies the heating roller target temperature for the ready condition.
Pressure Ready Temp
Sets the heating roller offset temperature at the end of the heating roller. This value is one of
007
the thresholds to determine if the machine is at the heating roller target temperature during
warm-up.
010 Stand-By: Center
011 Stand-By: End
8
Stand-By: Pressure
012
Sets the pressure roller offset temperature. This value is one of the thresholds to determine if
the machine is at the heating roller target temperature during warm-up.
013 Panel Off Mode: Center
014 Panel Off Mode: Ends
015 Panel Off Mode: Pressure
016 Low Power: Center
017 Low Power: Ends
018 Low Power: Pressure
019 Off Mode: Center
020 Off Mode: Ends
021 Off Mode: Pressure
144
*ENG [145 to 155 / 150 / 1 deg/step]
*ENG [0 to 150 / 20 / 1 deg/step]
* ENG
[140 to 170 / 160 / 1 deg/step]
* ENG
* ENG [105 to 135 / 125 / 1 deg/step]
* ENG [100 to 150 / 130 / 1 deg /step]
* ENG [100 to 150 / 130 / 1 deg /step]
*ENG [105 to 135 / 120 / 1 deg /step]
*ENG
[30 to 100 / 40 / 1 deg /step]
*ENG
*ENG [30 to 135 / 80 / 1 deg /step]
*ENG
[0 to 180 / 0 / 1 deg /step]
*ENG
*ENG [0 to 170 / 0 / 1 deg /step]