Troubleshooting - Unold 48946 Notice D'utilisation

TROUBLESHOOTING

Problem
The compressor hums
very loudly.
Indicator lamp shows
that the ice container
is full, even though it
is not full.
Indicator lamp shows
that the water level is
too low, even though
there is enough water.
Indicator lamp for low
water level is out, even
though there is no
water in the tank.
No indicator lamp
lights up when you
plug the appliance into
the wall socket.
The indicator lamps for
insufficient water and
full ice container blink
red at the same time.
The appliance is
working, but does not
make ice.
22
Cause
The voltage is too low.
The room temperature
is too cool.
Pieces of ice are
jammed.
The sensor is defective.
The water is not
conductive enough.
The water is not
conductive enough.
The sensor is defective.
The appliance is not
connected correctly.
A component is
defective.
An oversized ice
cube is blocking the
evaporator.
The motor in the
appliance is defective.
Coolant is leaking.
Solution
Switch off the appliance
and check whether it is
connected to a 220–
240 V~ wall socket.
Remove the ice
container and push it
back into the appliance.
Switch the appliance
off. Empty the ice
container and restart
the appliance. If the
problem persists,
contact our customer
service department.
Contact our customer
service department.
Add a pinch of salt to
the water in the water
tank.
Switch the appliance
off. Clean the water tank
thoroughly and restart
the appliance.
Contact our customer
service department.
Check to make sure that
the plug was inserted
correctly into the wall
socket.
Contact our customer
service department.
Switch the appliance
off. Wait until the ice
has melted. Start the
appliance again and
select a smaller ice cube
size.
Contact our customer
service department.
Contact our customer
service department.