Jaga OXRE.015 Instructions D'installation page 91

07
Use a mounting kit to secure the hose, both indoors and outdoors.
And install the outdoors grille.
09
Install the water temperature sensor on the tube of the heat
exchanger and plug the power plug into the wall socket
(230 V – 50 Hz).
11
Insert the touch control in the grill of the casing. Not applicable for device types: C2 and C5.
Clean the grill and remove grease from the area where the control will be attached.
08
Stick the supplied insulation around the 012.5 cm suction nozzle on
the rear (not if the connection collar is used, see 9.4).
Place the device in the correct position. Tighten the screws with a
screwdriver.
10
Now mount the casing.
1 2
EN
91