Mounting - Jaga OXRE.015 Instructions D'installation

11. MOUNTING
01
Place the radiator in accordance with the provided manual at the
location of the cover.
The wall mass must be minimally 200 kg/m². A lower mass can
increase the noise level.
03
Drill the hole (Ø130mm)
05
Insert 4 wall plugs and screw in the screws (5x60). If needed, use a
washer between the screw head and the mounting tabs.
Use a plug suitable for the type of wall. The plug provided are
suitable for solid walls only.
90
Place the drilling template as indicated.
the inner wall.
Ø 130 mm
± 5°
Drill the four holes to be used to mount the device using drill
diameter 8 mm.
5 mm
Jaga recommends using a hose diameter of 125 mm.
– d etermine the length of hose needed (indoors/outdoors sides
– r emove any burrs.
– r emove debris and clean the hose.
02
The window ledge may not stick out more than two cm from
04
06
must be level with the wall).
max. 2 cm
Ø 8mm ↓51mm